Craftsman 917.293310 - Manual (Page 7)

INSERT CABLE CLIP
• Insert plastic cable clip into hole on the
back of handle column. Push cables
into clip.
Attach this end to shift lever
Attach this End To shift Shift Rod
Lever indicator
Uatmir. i'lin Lever
■ Hairpin pp Indicator
Shift Rod
CONNECT SHIFT ROD
• Insert end of shift rod farthest from bend
into hole of shift lever indicator.
• Insert hairpin clip through hole of shift
rod to secure.
• insert other end of shift rod into hole in
shift lever.
• Insert second hairpin dip through hole of
shift rod with bend of clip on right side.
REMOVE TILLER FROM CRATE
• Adjust handle assemby to lowest posi­
tion. Be sure lock lever is tightened
securely.
• Make sure shift lever indicator is in “N”
(neutral) position. ^
• Tilt tiller fonvard by lifting handle.
Separate cardboard cover from leveling
shield.
• Rotate tiller handle to the right and pull
tiller out of carton.
Shift Rod
CHECK TIRE PRESSURE
The tires on your unit were overinflated at
the factory for shipping purposes. Correct
and equal tire pressure is important for
best tilling performance.
* Reduce tire pressure to 20 PSI.
HANDLE HEIGHT
• Handle height may be adjusted to better
suit operator. (See TO ADJUST HAN­
DLE HEIGHT in the Service and
Adjustments section of this manual).