Craftsman 917.293310 - Manual (Page 21)

PROBLEM CAUSE ; CORRECTION
Engine overheats 1. Low oil level/dirty oil.
2. Dirty engine air screen.
3. Dirty engine.
4. Partially plugged muffler.
5. Improper CEuturetor
adjustment.
1. Checkdllevel/changeoil.
2. Clean engine air screen.
3. Clean cylinder fins, air screen, muf
tier area.
4. Remove and clean muffler.
■ 5. Adjust carburetor to richer posi
tion.
Excessive bounce/
difficult handling 1. Ground too dry and hard.
2. V№eels and depth stake
inconectly adjusted.
1. Moisten ground or wait for more
favorable sdl conditions.
2. Adjust wheels and depth stake.
Soil balls up or
clumps
1, Ground too wet. 1. Wait for more favorable soil condi
tions.
Engine runs but
tiller won’t move
1. Tine control is not engaged.
2. V-belt not correctly adjusted.
3. V-belt is off pulley(s).
1. Engage tine control.
2. Inspect/adjust V-bett.
3. Inspect V-belt
Engine runs but
labors when tilling 1. Tilling too deep.
2. Throttle control not properly
adjusted.
3. Carburetor out of adjustment
1. Set depth stake for shallower till
ing.
2. Check throttle control setting,
3. Make necessary adjustments.
21