Craftsman 247.79452 - Manual (Page 6)

Make certain pump is mounted and aligned
properly
Use a flexible “spider” type coupling between
engine and pump drive shafts
Keep hoses clear and unblocked
Bleed air out of hoses before operating
Flush and clean hydraulic system before start­
up after any malfunction or sen/icing
Use “pipe dope" on ail hydraulic fittings
Aliow time for warm-up before spiitting wood ■
Prime the pump before initial start-up by turning
over the engine with spark piug disconnected
• Split wood with the grain (lengthwise) only
Never:
Use when fluid is below 20° F, or above 150° F.
Use a solid engine/pump coupling
Force pump when mounting
Operate through relief valve for several seconds
Attempt to adjust unloading or relief valve
settings without pressure gauges
Operate with air in hydraulic system
Use Teflon tape on hydraulic fittings
Attempt to cut wood across the grain.
ACCESSORIES
These accessories were available when the log
splitter was purchased. These are also available at
most Sears retail outlets, catalog and service centers.
Most Sears stores can order repair parts for you when
you provide the model number of your log splitter.