Cabletron Systems 6H129-08 - Manual (Page 86)

Chapter 5: Local Management
5-40 6H128-08 and 6H129-08 User’s Guide
SNMP TRAPS
The SNMP Traps screen provides display and configuration access to the
table of IP addresses used for trap destinations and associated community
names. For details, refer to
Section 5.17 .
SWITCH CONFIGURATION
The Switch Configuration screen provides basic setup options for
modifying switch operations in the network. For details, refer to
Section 5.18 .
ETHERNET INTERFACE CONFIGURATION
The Ethernet Interface Configuration screen indicates the link status,
current and desired operational mode, advertised ability, and flow control
admin status for ports 1 through 8 on the 6H12X-08. Refer to
Section 5.19 for details.
SMARTTRUNK CONFIGURATION
The SmartTrunk Configuration screen allows the user to logically group
interfaces together to aggregate high speed uplinks. Refer to the
Cabletron Systems SmartTrunk User’s Guide for additional information.
MODULE SPECIFIC CONFIGURATION
The Module Specific Configuration menu allows the user to access
screens to configure ports or check system resources specific to the
6H12X-08. For details, refer to
Section 5.21 .
5.15 GENERAL CONFIGURATION SCREEN
The General Configuration screen, Figure 5-18 , allows the user to set the
system date and time, IP address and subnet mask, and default gateway,
the TFTP Gateway IP address, the screen refresh and lockout times, the
Operational Mode, Management Mode, and COM port configuration. The
General Configuration screen also allows the user to clear NVRAM, and
set the IP Fragmentation.
To access the General Configuration screen from the Module
Configuration Menu screen, use the arrow keys to highlight the
GENERAL CONFIGURATION menu item and press ENTER. The
General Configuration screen,
Figure 5-18 , displays.