C.1 required tools, C.2 setting the mode switch, Appendix c – Cabletron Systems 6H129-08 User Manual
Page 161: Module(s), refer to, For installation instructions, Er to, Section c.2
6H128-08 and 6H129-08 User’s Guide
C-1
APPENDIX C
OPTIONAL INSTALLATIONS AND
MODE SWITCH BANK SETTINGS
This appendix covers the following items:
•
)
•
Locations, functions, and settings for the mode switches (
)
•
Installing optional Fast Ethernet Interface Modules (
)
C.1
REQUIRED TOOLS
You need the following tools to perform the procedures in this appendix:
•
An antistatic wrist strap (provided with 6C105 chassis).
•
A Phillips screwdriver is required when installing optional Fast
Ethernet Interface Modules for ports 7 and 8 into the 6H12X-08.
C.2
SETTING THE MODE SWITCH
These switches are set at the factory and do not need to be changed unless
you intend to perform the following:
•
Force download a new image file from a BootP server.
•
Clear NVRAM and restore all user-entered parameters such as the IP
address and subnet masks to the 6H12X-08 “default” configuration
settings.
•
Clear user-entered passwords stored in NVRAM and restore the
default passwords.
!
CAUTION
Only qualified service personnel should attempt the following
procedures.