Casio PX-400R - Manual (Page 9)

E-7
Using Tone Effects
Reverb: Makes your notes resonate
Chorus: Adds more breadth to your notes
1 Press the REVERB CHORUS button to cycle through
the effect settings as shown below.
• You can find out the current effect setting by looking at
the REVERB and CHORUS indicator lamps.
2 After turning on the effect you want, use the dial to
select the effect type you want.
• Note that you need to select an effect type with the dial
within a few seconds after turning on an effect. If you don’t,
the display will exit the setting screen.
Effect List
Selecting and Using Built-in Tones
419A-E-009B
Reverb Room 1
Room 2
Hall 1
Hall 2
Chorus Chorus 1
Chorus 2
Chorus 3
Chorus 4
R e v e r b T y p e :
[ R o o m 0 1 ] 0 0 0 0 0 0 0 0 0 0 0 0 0 0
C h o r u s T y p e :
[ C h o r u s 0 1 ] 0 0 0 0 0 0 0 0 0 0 0 0
Layering Two Tones
Use the following procedure to layer two tones, so they sound at
the same time.
1 Use the procedure under “Selecting a Tone” on page
E-6 to select the main tone.
Example: To select Grand Piano, press the PIANO button,
and then rotate the dial until “Grand Piano” is
displayed as the tone name.
2 Press the LAYER button.
• This causes the LAYER indicator lamp to light.
3 Select the layered tone.
Example: To select Strings
• This will cause the indicator lamp of the layered tone (the
second one you selected) to light.
• Now you can play using your layered tones.
4 After you are finished using the layered tones, press the
LAYER button again to unlayer them.
Adjusting the Volume of the Layered Tone
You can independently adjust the volume of the layered tone (the
second one you select). See page E-26 for more information.
On
Off
On
On
Both on
Both off
Reverb on
Chorus on
[ 0 0 0 : 0 S t r i n g s ]
0 P o p s 0 1
Grand Piano
Strings
PX400R_e_01-16.p65 04.8.24, 4:34 PM 7