Contents of hardware pack – Craftsman 917.293301 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
i
iiTin'
*
■* i’J “
I
li *'^'**«j?irt^''iiK ■»--”
FRONT
Your new tiller has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tiller
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness.
TOOLS fiEOUiRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) Tire pressure gauge
(1) Screwdriver
(1) Pair of pliers
{1)9/16" wrench
OPERATOR’S POSITION
When right or left hand is mentioned in
this manual,
it
means when you are in
the operating position (standing behind
tiller handles).
I yy y.yy
L.iZr^ I
OPERATOR’S
POSITION
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(1) Center Locknut
(1) Carriage Bolt 3/8-16 UNC
U-16UNCx1Gr.5
(1) cable Clip
(2) Hairpin Clips
u—.
■■
(1) Pivot Bolt
3/8-16 UNC Grade 5
Î (1) Flat Washer
13/32
X
1
X
11 Ga.
o
Extra Shear Pins &. Clips
(1) Handle Lock Lever