How to assemble the chute deflector, Raise the chute deflector into operating position, How to set the skid height – Craftsman 536881851 User Manual
Page 9: How to set the length of the cables, Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
NOTE; If the cables have become dis
connected, connect cables as shown in
Figure 7.
Traction Drive Cable Auger Drive Cable
Figure 7'
Nut
HOW TO ASSEMBLE THE CHUTE DEFLECTOR
1. Remove the carriage bolt. See
Figure 8.
2.
Raise the chute deflector into op
erating position.
3.
Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of carriage bolt on
the inside of the flange.
4. Fasten with washer and locknut.
5. Tighten locknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
Chute Deflector
Washer
Carriage Bolt
Flange
Figure 8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with
height adjust skids on the outside of the
auger housing. To adjust the skid
height for different conditions, see To
Adjust Skid Height paragraph in the
Service And Adjustment section.
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory
and no adjustments should be neces
sary. However, after the handles are put
in the operating position, the cables can
be too tight or too loose. If an adjust
ment is necessary, see “How To Check
And Adjust The Cables” in the Service
And Adjustment section.