How to remove the snow hood, Service and adjustment – Craftsman 536881851 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SERVICE AND ADJUSTMENT

HOW TO REMOVE

THE SNOW HOOD

To access the spark plug, the snow
hood must be removed as follows:

1. Remove the choke control knob

(see Figure 21).

2. Remove the safety key.

3. Remove the mounting screws

(see Figure 22).

4. Slowly remove the snow hood.

Make sure that the primer button

hose and the ignition wire are not
disconnected.

5. The spark plug can now be ac

cessed.

6. To install the snow hood, first make

sure that the primer button hose
and the ignition wire are connected.

7. Mount the snow hood to the engine

and secure with the mounting
screws (see Figure 22).

8. Connect the choke control knob

with the choke shaft on the carbure
tor (see Figure 23 and Figure 24).

Make sure the choke control knob is
properly installed. If the choke con

trol knob is not installed correctly,
the choke will not operate.

9. Install the safety key.

Choke

Control

Mounting Screws

Snow Hood

Spark

Plug

igure 22

Choke

Control Knob

Choke Shaft

Figure 21

Carburetor

Figure 24