beautypg.com

How to use your pressure washer, To start your pressure washer, Gaution – Craftsman 580.753000 User Manual

Page 9: Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

OPERATION

HOW TO USE YOUR PRESSURE

WASHER

If you have any problems operating your pressure

washer, please call the pressure washer helpline at

1-800-222-3136.

To Start Your Pressure Washer

To start your engine-powered pressure washer for the
first time, follow these instructions step-by-step. This

starting information also applies whenever you start

the engine after you have let the pressure washer sit

idle for at least a day.

1. Place pressure washer near an outside water

source capable of supplying water at a flow rate
greater than 3.7 gallons per minute and no less than

20 PSI at pressure washer end of garden hose.

2. Check that high pressure hose is tightly connected

to spray gun and pump. See "Assembling Your

Pressure Washer” for illustrations.

3. Make sure unit is in a level position.

4. Connect garden hose to water inlet on pressure

washer pump. Turn ON water.

GAUTION

DO NOT run the pump without the water supply
connected and turned on.

Damage; to ;equipment; will result; from failure to; follow

: this: instruction.:^

6.

6

.

Squeeze trigger on gun to purge pump system of
air and impurities.

Place colored quick connect spray tips in slots on
holder that’s attached to nozzle extension.

7. Attach nozzle extension to spray gun. Tighten by

hand.

10. Rotate fuel shut-off valve to "On" position (fully

counter-clockwise).

Fuel Valve shown in ^

“On” position

t.'

11. Move variable pressure control lever to "High"

position, shown on engine as a rabbit.

12. Move choke lever to “Choke” position.

NOTE: For a warm engine, be sure the choke lever is
in the “Run” position.

13. Grasp handle and pull the recoil starter lightly until

you feel some resistance, then pull briskly.

14. Return recoil starter slowly. DO NOT let rope

"snap back" against starter.

15. When engine starts, slowly move choke lever to

"Run” position as engine warms. If engine falters,
move choke lever to “Choke” position, then to
"Run” position.

16. If engine fires, but does not continue to run,

squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 13 through 15.

17. If engine fails to start after six pulls, move choke

lever to “Run" position, and repeat steps

13 through 15.

GAUTION

8. Choose spray tip you want to use and insert it into

nozzle extension. See "How to Use Spray Tips" on
page 10.

9. Engage safety latch to spray gun trigger.

Safety Latch;

Avoid injury from kickback.

When;starting; engine,; pull; cord slowly until resistance is

ielt and; then; pull; rapidly to avoid kickback.

If engine starts and fails; to continue to run or if increased
resistance; is; felt during; starting; pull attempts, squeeze
trigger on spray gun:;; ; ; ; ; T