Sony SLV-M91HF - Manual (Page 66)

Registering the contents of a recorded tape in the SmartFUe label
(continued)
To check the information of a registered program
Press SMARTFILE.
The SmartFile search list appears. The registered program number,
registration date and recording time appear in diis list. Note that the
registration date differs from the recorded date.
lEal
roarwn No.«
g 2 h 10 m
Program No.t
0^
m
Proorom No.4
Registration date
— Recording time
Program located in
a recorded tape
Estimated position of the registered program
Tips
• The programs recorded on the tape can be registered again in a SmartFile label that
already contains program data. However, the recorded date rmd time, program
name and information input manually (such as the program label and category) are
replaced with "Program No. XX".
• If the SmartFile label contains stored program data that includes protected
programs, a message appears and registration stops.
Notes
• Program data is not registered correctly in the SmartFile label when;
- the program length is about 20 minutes or less in EP mode or about 7 minutes or
less in SP mode.
- the program does not have an index signal or the index signal has been recorded
over and erased.
- the tape is damaged or dirty.
• If you don't set the clock or the clock isn't set to the correct date, the registration
date won't be stored correctly on the SmartFile list.
• After you press SMARTFILE GENERATOR and start registration, registration is
interrupted if you press ■ STOP, I> PLAY, ►► FF, ◄◄ REW, 1/(1) or /►►!
INDEX SEARCH. In these cases as welL the data registered up to the point when
registration was interrupted remains in the SmartFile label.
• Tape speed may not be registered correctly when;
-you set AUTO TAPE SPEED to ON in the ADVANCED OPTIONS menu, and the
tape speed automatically changes from SP to EP during recording.
- you use tapes recorded in the LP mode on other VCRs.
66 SmartFile Function