Sony CCD-TR61 - Manual (Page 25)

[Advanced Operations!
Using Alternate Power Sources
You can choose any ot the following power sources for your camcorder battery pack (p. 7), house
current and 12/24 V car battery. Choose the appropriate power source depending on where you want to
use your camcorder.
Place Power source Accessory to be used
Indoors House current AC power adaptor AC-V25A/2SA (supplied). AC-S10,
AC-V55
Outdoors Battery pack Battery pack NP-SS (supplied), NP-77HD, NP-77H,
NP-77, NP-66H, NP-S5H
In the car 12 V or 24 V car battery DC pack DCP-77
Using House Current
To use the supplied AC-V25/V25A AC power adaptor: (1) Lift up the viewfinder. (2) Connect the AC power
cord to a wall outlet The POWER lamp (green) lights up. Connect the bottom of the AC power adaptor to
the batter>* mounting surface of the camcorder. (3) Set the selector to VIR (OC OUT).
1
I
I
00
s
I*
o
Note on the POWER lamp
e The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to OFF and disconnect the power cord. After about
one minute, reconnect the power cord and set the selector to VTR (DC OUT) again.
To remove the adaptor
The adaptor is removed in the same way as the battery pack. (p. 7)