Sony LBT-G5500 - Manual (Page 8)

step 3: Presetting radio stations
{continued)
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
"MANUAL" appears in step 2 , then press
TUNING +/- to tune in the station.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(Except for the European and the
Middle Eastern models)
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval to 10 kHz (or 9 kHz), press TUNER/BAND
repeatedly until "AM" appears first, then turn off
the system. While holding down ENTER/NEXT,
turn the system back on. When you change the
interval, the AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Note
The preset stations are canceled when you
disconnect the power cord or if a power failure
occurs for half a day.
Connecting
optional AV
components
To enhance your system, you can connect
optional components. Refer to the
instructions included with each component
for details.
Connecting audio
components
Connecting a turntable
Be sure to match the color of the plugs and
the connectors. To listen to the sound from
the connected turntable, press FUNCTION
repeatedly until "PHONO" appears.
To the audio output of the turntable
Note
Using the turntable at high volume may cause
distortion or howling. This is often caused by the
bass sound from the speakers. The bass sound may
be picked up by the needle of the turntable, and
produce the distortion or howling. To avoid this, do
the following;
1 Keep some distance between the speakers and the
turntable.
2 Stop using the surround effect.
3 Install the speakers or the turntable on a firm and
stable surface.
4 Press DBFB repeatedly until "DBFB ^\\\\\ "
disappears from the display (LBT-D390/G5500/
XB33/XB33K/XB50 only).
Press SUPER WOOFER repeatedly until the
indicator on this button goes off (except for LBT-
D390 / G5500 / XB33 / XB33K / XB50).