Sony LBT-G5500 - Manual (Page 42)

CD Player Tuner
The CO tray does not rotate.
• A CD is not placed properly.
A CD will not play.
• The CD is not lying flat in the disc tray.
• The CD is dirty.
• The CD is inserted label side down.
• .Moisture condensation has built up.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates. •
Play does not start from the first track.
• The player is in Program or Shuffle Play
mode. Press PLAY MODE repeatedly
until “PROGRAM" or "SHUFFLE"
disappear from the display.
Tape Deck
The tape does not record.
• No tape is in the cassette holder.
• The tab has been removed from the
cassette (see page 40).
• The tape has reeled to the end.
The tape does not record nor play, or there
is a decrease in sound level.
• The heads are dirty. Clean them (see page
40).
• The record / playback heads are
magnetized. Demagnetize them (see page
40).
The tape does not erase completely.
• The record/playback heads are
magnetized. Demagnetize them (see page
40).
There is excessive wow or flutter, or the
sound drops out.
• The capstans or pinch rollers are dirty.
Clean them (see page 40).
Noise increases or the high frequencies are
missing.
• The record / playback heads are
magnetized. Demagnetize them (see page
40).
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display).
• Adjust the antenna.
• The signal strength is too weak. Connect
an external antenna.
A stereo FM program cannot be received in
stereo.
• Press STEREO/MONO so "STEREO"
appears in the display.
If other problems not described
above occur, reset the system as
follows:
(LBT-D390/D790/G5500/XB33/XB33K/
XB44/XB44K/XB50/XB60 only)
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press GROOVE, ENTER/NEXT, and DISC
1 at the same time.
(LBT-XB66/XB66K/XB660 only)
1
Unplug the power cord.
2 Plug the power cord back in.
3 Press SPECTRUM ANALYZER, ENTER,
and DISC 1 at the same time.