Sony LBT-G5500 - Manual (Page 2)

WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
Laser component in this product is capable of
emitting radiation exceeding the limit for Class 1.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
This caution label is located inside the unit.
I CLASS ’ LASER RflOOUCT I
LLKXAN
1 LASCRLAiTE I
KLASS 1 LASCAAPMRAT H
AtJVXITSrr ; USVNUO LASCnSTRAUNO VCD AaNMO n A r
SHUCCRHCOSAFWrrDCRC CR UX tt FDNKTION. UNOOA UOSACTTELSE
FOR CTFtAONG
C i CCRCROCKT NtCHT MM ITRAHi AUS8CTZEN.
VAFÎ07
VARNING ; OmCMOLASCRSnUUNONARHMMSCLARâRRMÂÔ
OCM SRiAFtew AR URKORRUM? MTIWCTA CJ STRAUW______
A^DVERSEL : osnua laserstr A ung n A r ocksel A rnes oo
SRtKCRHCML^WFVTCt OKNOA CKSROWtWWO FOR CTRAtCN.___________________
VIGYAZAT/ : AiuRKoukT MvrrAaAKOR latmawlan lczersu -
sarvcsz C lti kcr C ajc a tcmaÀRzArr»____________________________
NOTICE FOR THE CUSTOMERS IN THE
U.S.A.
A A
CAOTION TO RCOUCC TX nSK OF eUCTRIC smock
oo MOT REMOVE COVER lOH SACKl
NO USCR-SERVICEAM.E FARTS MS«E
REFER SERVICINQTOOUAUFIEOSCRVCERERSONNEL
This symbol is intended to alert the
user to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
accompanying the appliance.
CAUTION
iTie use of optical instruments with this product will
increase eye hazard.
INFORMATION
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures;
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
CAUTION
You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.
Note on CATV system installer:
This reminder is provided to call CATV system
installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building,
as close to the point of cable entry as practical.
NOTICE FOR THE CUSTOMERS IN
CANADA
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO NOT USE
THIS POLARIZED AC PLUG WITH AN
EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
This stereo system is equipped with the Dolby* B-
type noise reduction system.
* Dolby noise reduction manufactured under license
from Dolby Laboratories Licensing Corporation.
"DOLBY" and the double-D symbol □□ are
trademarks of the Dolby Laboratories Licensing
Corporation.
(Çg
(LBT-XB50/XB60only)