Sony SPP-71 - Manual (Page 11)

■ If you are not sure
1 Make a trial call with the DIAL MODE
switch set to "T".
2 If the call is connected, leave the switch
at “T".
Otherwise, set the switch to "P".
Charging the battery
pack B
* •
The handset operates on the battery pack.
The supplied battery pack must be charged
before you can use it. Allow the battery
pack to charge for about 12 hours.
Notes on charging
• Make sure the CHARGE lamp on the base
unit lights when you place the handset onto
the base unit. If the CHARGE lamp remains
off, charging cannot start.
• Tlie CHARGE lamp still lights after charging
is completed.
• After you have completed a telephone
conversation, replace the handset onto the
base unit.
■ How to determine battery
damage
If the battery duration becomes extremely
short after you have charged the batterj' for
o\’er 12 hours, the battery is probably
damaged. See your dealer or contact a
Sony Serx'ice Center for battery
replacement.
■ Battery duration
See "Specifications".
■ When the battery becomes low
during conversation
The T a \LK/BATT LOW lamp flashes and
the phone will beep every three seconds. If
this happens, disconnect the line and
replace the handset onto the base unit to
charge the battery pack for a while.
! If the battery becomes completely
discharged
Tile digital sc\:urity ccxie will be erased and all
programmed numbers will be lost from
memory.
In this case, first recharge the battery for more
than 12 hours, then store the numbers into the
memory for speed dialing again (see
".Memory dialing"). The security c
automatically set when you replace the
handset onto the base unit.
Making/Receiving calls
1
To make or receive calls, press
TALK.
To make calls, wait until the TALK/
ВАТТ LOW lamp lights and you hear a
dial tone. Then dial a phone number.
2
When you finish talking, replace
the handset onto the base unit, or
press TALK again.
! If fi\'e short error beeps sound and the line is
not disconnected when you press TALK,
mo\ e closer to the base unit and press TALK
again, or replace the handset onto the base
unit.
! Do not remove the battery pack from the
handset while you are talking on the phone.
Иле line may remain connected.
! If electric interruption cKcurs during
telephone conversation and you cannot
disconnect tire line on the handset, remove the
battery pack once and install it again
■ If interference occurs during
conversation
First, bring the handset closer to the base
unit. If interference still persists, press
CHANNEL.
The phone will switch to another channel.
! II \4>u try to change the channel when the
handsel is t
short error hc4'ps will sound and the channel
леМ1 not change.