Sony KP-53V75 - Manual (Page 45)

Operating a cable
box or DBS receiver
Press DBS/CABLE (POWER) to turn on the
cable box or DBS receiver.
DBS/CABLE
You can program the supplied remote control to
operate a cable box or DBS receiver. Follow the
procedures below to set the manufacturer's code
number in the remote control.
m
DISPLAY*
JUMP ■
TV/DBS* ■
CODE SET
o ^ cE©
CZ) CD cij CD
CD CD CaD C3D
o © © ©
o © © ©
CDOD CD CD
© © @
© ® ®
© @ @
GD
©-
■ DBS/CABLE (POWER)
DBS/CABLE
(FUNCTION)
- 0 - 9 buttons
-ENTER
-GUIDE*
-♦/♦/•/♦/ gd *
-MENU*
■ CH +/-
* The TV/DBS GUIDE, DISPLAY, ♦/♦/♦/♦/(
buttons can be us.rd only with a DBS receiver.
U and MENU
1 Turn off the equipment you want to set up,
and press DBS/CABLE (FUNCTION).
Press the CODE SET, DBS/CABLE (FUNCTION),
and 0-9 buttons to enter the
manufacturer's code number (see the chart
on the right column), then press ENTER. For
example, to program your remote control
to operate a Sony DBS receiver, press CODE
SET, DBS/CABLE (FUNCTION), 8, 0, 1, and
ENTER.
-- ^UNCTON----
CODE SET DBS/CABLE
+ +
s s
4 Use the cable box/DBS control buttons to
check if the code number works.
For example, to operate a cable box or DBS receiver,
you can use the DBS/CABLE (POWER), JUMP, CH
+ / - , 0 - 9 and ENTER buttons.
Note
• If the cable box or DBS receiver does not have a certain
function, the corrcspond-.ng button on this remote control will
not operate.
To operate the projection TV
Press TV (FUNCTION). Then use the projection TV
control buttons to control the projection TV.
For more details on operating the cable box or
DBS receiver
Refer to the operating instructions that come with the ________
equipment. m
If the remote control doesn't work
• First, try repeating the se;up procedures using the other codes
listed for your equipmer.;.
Manufacturer code numbers (cable box)
Manufacturer Code number
Hamlin/Regal 222, 22,'i, 224, 225, 226
|errold/G. I. 20U 202, 203, 204, 205, 206, 207, 208,
218
Oak 227, 22S, 229
Panasonic 219, 220. 221
Pioneer 214. 21.-
Scientific Atlanta 209, 210, 211
Tocom 216,217
Zenith 212, 213
Manufacturer code numbers (DBS receiver)
Manufacturer Code number
Sony 801 {preset code for the supplied
remote control)
RCA 802
Notes
• If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this remote control and you may not be able to
operate your equipmen; with the supplied remote control. In
this case, use the equipment's own remote control unit.
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code numbers may
revert to the factory setting and must be reset.
Operations
45-EN