Sony KP-6lHS20 - Manual (Page 70)

other Information
Troubleshooting
If, after reading these operating instructions, you have additional questions reiated to the use of your
Sony television, please call our Customer Information Services Center at 1-800-222-SONY (7669) (U.S.
residents only) or (416) 499-SONY (7669) (Canadian residents only).
Problem
No picture
(screen not lit),
no sound
Remote control
does not operate
Dark, poor or no
picture (screen lit),
good sound
Good picture,
no sound
Cannot receive digital channels □
(when a DTV receiver is
connected) □
Cannot receive upper channels □
(UHF) when using an antenna □
No color
Only snow and noise
appear on the screen
Dotted lines
or stripes
Possible Remedies
□ Make sure the projection TV’s power cord is connected securely to the wall outlet.
□ Push the power button on the front of the projection TV.
□ Check to see if the TV/VIDEO setting is correct; when watching TV, set to TV,
and when watching connected equipment, set to
VIDEO 1, 2, 3, 4, 5 or 6.
□ Try another channel. It could be station trouble.
□ The Parental Control feature is activated (see “Using the Parent Menu’’ on page
54).
□ If your projection TV does not turn on, and a red light keeps flashing, your
projection TV may need service. Call your local Sony Service Center.
□ Batteries could be weak. Replace the batteries.
□ Press TV (FUNCTION) when operating your projection TV.
□ Make sure the projection TV’s power cord is connected securely to the wall outlet.
□ Locate the projection TV at least 3-4 feet away from fluorescent lights.
□ Check the orientation of the batteries.
□ Adjust the Picture setting in the Video menu (see page 48).
□ Adjust the Brightness setting in the Video menu (see page 48).
□ Check antenna/cable connections.
□ Adjust the convergence again using FLASH FOCUS (see “Adjusting the
Convergence Automatically - FLASH FOCUS^^“ on page 33).
□ Press MUTING so that “MUTING” disappears from the screen (see page 34).
□ Make sure Speaker is set to ON in the Audio menu (see page 51).
□ Check the MTS setting in the Audio menu (see “MTS” on page 50).
Check the connections between the DTV receiver and the projection TV (see page
28).
Check your local listings to find out if you can receive digital broadcasts in your
area.
Change Cable to OFF (see page 52).
Use Auto Program in the Channel menu to add receivable channels that are not
presently in TV memory (see page 53).
&
□ Adjust the Color settings in the Video menu (see page 48).
□ Check the Cable setting in the Channel menu (see “Cable” on page 52).
□ Check the antenna/cable connections.
□ Make sure the channel is broadcasting programs.
□ Press ANT to change the input mode (see page 37).
□ Adjust the antenna.
□ Move the projection TV away from noise sources such as cars, neon signs, or hair­
dryers.
70