If the battery becomes weak during a call, Making calls through the speakerphone – Sony SPP-SS965 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Notes
• When you increase the sound volume, in some cases the back ground noise
may be increased as well. You should adjust the volume accordingly.
• If the handset beeps every second during conversation and "OUT OF
RANGE" appears on the display, move closer to the base phone; otherwise,
the call will be disconnected after one minute.
• While conversing with .an outside caller via the base phone, you can't make a
call with the handset and "BASEPHONE IN USE" appears on the display. U
you press (
TALK/ CALL WAITING/ FLASH), you will hear a busy tone.
• When the operation duration exceeds 9:59'59, the display counts from 0:00'00
again.
If the battery becomes weak during a call
Th'e handset will beep every three seconds five times and rXi and
"BATTERY LOW" appears on the display. Finish your call and charge
the battery pack.
For optimum performance, charge the battery for a full 12 hours.
Note that during the first 10 -15 minutes of charging, the phone will be
inactive, i.e., unable to make or receive a call.
After this initial 10 -15 minutes, you
may
be able to use the phone, but
the battery duration will be
very short;
thus it is recommended that
you
fully charge
the battery before the next usage.
Making calls through the speakerphone
Press (
SPEAKERPHONE
) on the base
phone.
"SPEAKERPHONE" appears on the
display and the display also shows the
operation duration in hours, minutes and
seconds.
n
u
!S.
ft*
u>
The LINE lamp lights up.
Dial the phone number.
To adjust the speaker volume, slide the
SPEAKER VOLUME control.
When you're done talking, press
(SPEAKERPHONE)
again.
Notes
• While conversing with an outside caller via the handset, the display on the
base phone shows "HANDSET IN USE" and you can't make a call through
the speakerphone. If you press (
speakerphone
i. you will hear a busy tone.
• When the operation duration exceeds 9:59'59, the display counts from 0:00'(K1
again.
continued
Basics
1 5
“