Sony CCD-TR23 - Manual (Page 19)

I
Advanced Operations
Using Alternate Power Sources
You can choose any of the following power sources for your camcorder: battery pack (P.6), house
current, and 12/24 V car battery. Choose the appropriate power source depending on where you want to
use your camcorder.
Place Power sources Accessory to be used
Indoors House current
AC power adaptor AC-V25A/V25B/V25C (supplied),
AC-SIO, AC-V55
Outdoor Battery pack
Battery pack NP-55 (supplied), NP-80/80D, NP-77H,
NP-66H, NP-60D, NP-68, NP-C65
In the car 12 V or 24 V car battery DC pack DCP-77
a
This mark indicates that this product is a genuine product related to our 8mm video
equipment. When purchasing our 8mm video equipment, we recommend that you
purchase related 8mm video products provided with the same mark or products
provided with our logotype mark.
Using House Current
To use the supplied AC-V25A/V25B/V25C AC power adaptor:
(1) Lift up the viewfinder. (2) Connect the AC power cord to a wall outlet. Connect the bottom of the
AC power adaptor to the battery mounting surface of the camcorder. (3) Set the selector to VTR (DC
OUT).
5 ' IQ
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to the center position and disconnect the power
cord. After about one minute, reconnect the power cord and set the selector to VTR (DC OUT) again.
To remove the adapter
The adaptor is removed in the same way as the battery pack, (p.8)
19