Sony SLV-677HF - Manual (Page 8)

Step 3: Hookups (continued)
Audio/video (A/V) hookup Page 8 1
If your TV has audio/video (A/V) input jacks, you will get a better picture
and sound when you hook up your VCR using these connections. In
addition, for a true "home theater" experience, you should connect the audio
outputs of your VCR or TV to your stereo system. If your TV doesn't have
A/V inputs, see the following pages for antenna or cable hookups.
If you're not planning to use your VCR to record programs, you're finished
setting up the VCR after you've made the connections shown on this page.
If you want to record off-air or off your cable TV system, complete these
cormections first, and then go to the following pages for antenna or cable
hookups.
□ Use this hookup if your TV has stereo jacks
VCR stereo receiver
AUDtO VIDEO
LINE-1 IN 0® 0
Audio/video cable (supplied)
ID
Use this hookup if your TV doesn't have stereo jacks
VCR stereo receiver
Vjdeo cable (not supplied) Audio cable (not supplied)
Note
To play a tape in stereo, you must use the A/V connection.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
Getting Started