General setup information, Setting the rf unit – Sony SLV-677HF User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Additional Information
General setup information
Setting the RF unit
when connecting the VCR to the TV
using only the antenna cable, you must
set the RF UNIT switch on the rear of the
VCR so that the TV can receive the
correct signal from the VCR.
TV
1
Set the RF UNIT switch on the rear of the VCR to CH 3 or CH 4,
whichever channel is not used in your area. If both are used, set the
switch to either channel.
2
Press POWER to turn on the VCR.
3
Press TV/VIDEO on the remote commander to turn on the VIDEO
indicator in the VCR's display window.
4
Press CHANNEL +/ - to display a channel number in the display
window. Select an active channel number in your area.
5
Turn on your TV and set it to the channel you selected in step 1
(charmel 3 or 4).
The selected TV channel broadcast appears on the TV screen. If the
channels change when you press CHANNEL +/-, you have made the
correct setting.
Whenever you use the VCR, set the TV to the channel selected in step 1.
Additional Information