Sony CDX-C8850 User Manual
Page 52
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Warm the mounting surface and the double-sided
adhesive tape on the mounting hardware @ to the
temperature of 20°C (68°F) to 30°C (86°F), and attach the
mounting hardware to the mounting surface by
applying even pressure. Then screw it down with the
supplied screw
® .
.Attach a piece ot lioa\ \' duty tape, etc. on the other side of
the mounting surface to cover the protruding tip of the
screw so that thev will not interfere with anv electrical
cables, etc. inside the steering wheel column.
After installing the steering wheel column cover, attach the rotary commander to the
mounting hardware by aligning the four holes on the bottom of the rotary
commander with the four catches on the mounting hardware and sliding the rotary
commander until it locks into place as illustrated.
Note
If you are mounting the rotary commander to the steering wheel column, make sure that the
protruding tip of the screw on the inner surface of the column does not in any way hinder or
interfere with the movement of the rotating shaft, operative parts of the switches or the electrical
cables, etc. inside the column.