Sony SPP-D900 - Manual (Page 6)

Redialing
1
Press (TALK) and wait until the TALK lamp lights up.
2 Press ( REDIAL/PAUSE) to redial the number last dialed.
Note
If the number exceeds .12 digits or there is no previous number dialed, the beeps will
alert you that the number can't be dialed.
To erase the last phone number dialed
Set the RING ON/BATT SAVE .switch to RING ON. While the
hand.set isn’t in u.se, pre.ss (REDlAiyPAUSE) twice.
The number will be era.sed from the memory, and you’ll hear a long
confirmation beep.
Ш
a
!S.
n’
(Л
Receiving calls
TALK lamp
1
(FLASH)
When you hear the phone ring, pre.ss
(TALK) (or any dialing key
including ® and CD).
The TALK lamp lights up.
When you’re done talking, press
(TALK), or replace the hand.set on
the base unit.
The TALK lamp goes off.
(MUTE)
RING ON/BATT SAVE
00 Additional tasks
To Do this
Put a call on mute Press CMUTE).
Press the button again to resume the
conversation.
Switch to another call* Press f FLASH).
(“call waiting” service) Press the button again to get back to the
first caller.
Adjust the volume of incoming Press (VOL). High or low volume
calls can be selected alternately.
• You need to subscribe to this service from your telephone company.
Tip
If you do not want to be disturbed by telephone calls, you can turn the ringer off.
Move the RING ON/BATT SAVE switch to:
• RING ON to turn the ringer on.
• ВАТТ SAVE to turn the ringer off to save battery power. In this setting, the
handset does not ring when a call comes in. However, as the LINE lamp on the
ba.se unit Hashes and informs you of incoming calls, you can still receive calls. This
setting is useful if you u.se this cordless telephone as an extension telephone and
you can hear the other phone ring.
Basics 15^'^ Basics