Steps, Preparing the battery pack for the handset, Steps preparing the battery pack for the handset – Sony SPP-D900 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
О)
steps
Preparing the battery pack for
the handset
Insert the battery pack into the handset, then place the handset on the
base unit.
C\
insert the battery pack
1
A
3
Slide open the battery compartment lid of the handset. Si
2
Connect the cord of the battery pack correctly.
3
Insert the battery pack into the battery compartment.
Replace the battery compartment lid.
Step 3: Preparing the battery pack for the handset (continued)
Charge the battery pack
Place the handset on the base unit.
Battery duration
A fully charged battery pack lasts for about:
• 7 hours when you use the hand.set continuously.
• 7 days when the handset is in standby mode.
You can save the handset battery power by setting the RING ON/
ВАТТ SAVE switch to ВАТТ SAVE. The handset won't ring (see
page 16).
Notes
• The battery pack will gradually discharge over a long period of time, even if not in
use.
• The CHARGE lamp of the base unit is always lighted when the handset is placed
on the base unit, even if the battery pack has been fully charged.
Getting Started
I
11'
12™ I Getting Started