Hooking up the system, Hookups, Connecting the tape deck to an amplifier – Sony TC-WR550Z User Manual
Page 4: Connecting the ac power cord, Unpacking, Getting started, Where do i go next
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Unpacking
Check that you received the following items:
• Audio connecting cords (2)
Connecting the tape deck to a CD player eqipped with
a CONTROL A1 connector (TC-WE805S/WE705S/WE605S
only)
For information on connections through the CONTROL
A1 connectors, refer to the pamphlet included with this
manual.
Hooking Up the System
This section describes how to hook up the tape deck to
an amplifier or a CD player equipped with CONTROL
A1 connectors {TC-WE805S/WE705S/WE605S only).
Be sure to turn off the power of each component before
making the connections.
Tape deck
Signal flow
Hookups
• Connecting the tape deck to an amplifier
Connect the amplifier to the LINE IN/OUT connectors
using the supplied audio connecting cords.
When connecting an audio connecting cord, be sure to
match the color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to White.
Be sure to make connections firmlv to avoid hum and
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
tape deck is set to the local power line voltage. If not,
set the selector to the correct position using a
screwdriver before connecting the AC power cord to
an AC outlet.
220V
240V
20V
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
Where do I go next?
Now you're ready to use your tape deck.
For basic operations, go to pages 5 to 7; for advanced
operations, go to the sections starting from page 8.
Tape deck
Amplifier
Signal flow