4 connect the router to the network, Console and auxiliary port cable connections, Connect the router to the network – Cisco ASR 1004 User Manual
Page 12: Con—console port, Aux —auxiliary port, Status, St at us
12
Step 5
Locate the chassis ground connector on the side of your chassis.
Step 6
Insert the two screws through the holes in the grounding lug.
Step 7
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the
chassis. Do not overtighten the screws.
Step 8
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate
chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the
“Connect the Router to the Network” section
for information on attaching cables.
4
Connect the Router to the Network
This section provides information about cables and ports and attaching the router to the network.
•
Console and Auxiliary Port Cable Connections, page 12
•
Management Ethernet Port Cable Connection, page 13
•
Connect the Shared Port Adapter Cables, page 14
•
Install Cables in the Cable-Management Bracket, page 14
Console and Auxiliary Port Cable Connections
This section describes how to attach a cable to the console or auxiliary ports on the Cisco ASR 1004 Router.
The Cisco ASR1004
Router uses RJ-45 ports for both the auxiliary port and console port to attach a modem or console terminal.
The console DCE-mode port connects a console terminal and a DTE-mode auxiliary port connects a modem or other DCE device
to your router.
Note
Both the console and the auxiliary ports are asynchronous serial ports; any devices connected to these ports must be
capable of asynchronous transmission. (Asynchronous is the most common type of serial device; for example, most
modems are asynchronous devices.)
Step 1
Before connecting a terminal to the console port, configure the terminal to match the router console port as follows:
9600 baud, 8 data bits, no parity, 1 stop bits.
Figure 8
Cisco ASR1000 Route Processor Console and Auxiliary Port Connectors
1
CON—console port
2
AUX —auxiliary port
MIN
AC
O
MAJ
STBY
ACTV
STAT
ASR1000-
RP1
PWR
CRIT
0
SPA-4XOC3
-POS
0
1
2
3
A
A
/L
C/A
A
/L
C/A
A/L
SPA-4XOC
3-POS
S
TATUS
0
1
2
3
C/
A
A
/L
C/A
A
/L
C/A
A
/L
C/A
A
/L
SPA-4XOC
3-POS
S
T
AT
US
0
1
2
3
C/
A
A
/L
C/A
A
/L
C/A
A
/L
C
/A
A/L
BITS
CON
AUX
CARRIER
LINK
MGMT ETH
ERNET
DISK
HD
USB
DF
0
1
280181
1
2