Two Brothers Racing Polaris RZR 800 Coil Kit User Manual
Page 2
16)
Check that all wires are routed securely, and away from exhaust.
17)
Connect the battery. Replace transmission duct, engine cover, and seats.
18)
Turn ignition key on. Start the engine. Installation is complete!
1. New plug wire and terminals.
2. Tools required.
3. Original Boot, pulled off.
4. Cut new wire at 24 inches.
DYNATEK
164 S. Valencia St., Glendora, CA 91741 800-928-3962
www.dynaonline.com
2801398B
5. New wire sleeved.
6. Grease wire and boot.
See also other documents in the category Two Brothers Racing For the car:
- Aprilia Falco (1 page)
- Aprilia Mille (1 page)
- BMW F650GS (2 pages)
- BMW F650GS (3 pages)
- BMW F650GS (1 page)
- BMW F800R (1 page)
- BMW F800S/ST (2 pages)
- BMW K1200RS (1 page)
- BMW K1300S (2 pages)
- BMW K1300S (5 pages)
- BMW R1100GS (1 page)
- BMW R1100RT (1 page)
- BMW R1100S (1 page)
- BMW R1150GS Adventure (1 page)
- BMW R1100R/850R (1 page)
- BMW R1150RT (1 page)
- BMW R1200GS (2 pages)
- BMW R1200GS (3 pages)
- BMW R1200GSA (2 pages)
- BMW S1000RR (1 page)
- BMW S1000RR (4 pages)
- BMW S1000RR (5 pages)
- Buell M2 (1 page)
- Can-Am Commander (2 pages)
- Can-Am Outlander 1000R (2 pages)
- Can-Am Outlander Max 800R (2 pages)
- Can-Am Renegade 800R / Outlander (2 pages)
- Can-Am Spyder RT (2 pages)
- Can-Am Spyder (2 pages)
- Ducati Monster 696 (2 pages)
- Ducati 1098/848 (2 pages)
- Ducati 748/916 (1 page)
- Ducati 750 Sport (1 page)
- Ducati 750SS (1 page)
- Ducati 996 (1 page)
- Honda 599 (2 pages)
- Honda 919 (3 pages)
- Honda 919 (1 page)
- Honda 919 (2 pages)
- Honda CB300R (1 page)
- Honda CB1000 (1 page)
- Honda CBR125R (1 page)
- Honda CBR250R (1 page)
- Honda CBR250R (2 pages)
- Honda CBR250R (5 pages)