Two Brothers Racing Yamaha R1 - Manual (Page 3)

ITBR001-238 2009-10 Yamaha R1 - 3
Fi
gu
re
A
Fi
gur
e B
Fi
gu
re
C
remove
Juice Box Pro
harness
ground wire
unplug
The ignition must be turned OFF before installation.
1 Remove the main seat.
2 Lift the front of the fuel tank up and use something to keep it propped up.
3 Remove the inner fairing on the left hand side of the bike as shown in Figure A.
4 Lay the Juice Box Pro near the battery and route the Juice Box Pro harness down the
left hand side of the bike.
5 Route the harness underneath the battery bracket as shown in Figure B.
6 Attach the ground wire from the Juice Box Pro to the negative side of the battery as
shown in Figure B.
7 Unplug the 3-pin and 4-pin green connectors from the throttle bodies to the main
wiring harness as shown in Figure C.
These connectors are located to the inside of the frame on the left side.