Two Brothers Racing Kawasaki ZX-10R - Manual (Page 3)

ITBR001-199 2008-10 Kawasaki ZX10R - 3
Fi
gu
re
A
Fi
gur
e B
Fi
gu
re
C
remove cover
Juice Box Pro
harness
unplug
The ignition must be turned OFF before installation.
1 Remove the main seat and the passenger seat.
2 Remove the covers for each side of the fuel tank as shown in Figure A.
3 Prop the front of the fuel tank up.
4 Slide the junction box under the main seat from it’s rubber sleeve.
This will allow room for the Juice Box Pro harness.
5 Route the Juice Box Pro wiring harness underneath the sub frame crossover as
shown in Figure B.
6 Unplug the brown 16-pin main wiring harness connector from the throttle bodies as
shown in Figure C.
This connector is located under the fuel tank on the right hand side of the bike.