Two Brothers Racing Cleaning User Manual
Tbr-001 screen type spark arrestor

In order to maintain optimal performance it
is recommended that this spark arrestor be
cleaned after every 30 hours of use.
Two Brothers Racing
TBR-001 Screen Type Spark Arrestor
part # 005-105S
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install
this performance part, please consult with your local motorcycle dealer.
Read all instructions first before starting installation. Make sure the
motorcycle and exhaust system are completely cool before starting the
installation. Also, make sure the bike is secure on a centerstand or
ideally a service lift during installation. Be sure to save all stock
components for possible use later.
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold
“as is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness
for a particular purpose and disclaims all responsibility for consequential and incidental damages or any other
losses arising from the use of these products or parts.
Warranty
1. Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on a
centerstand or ideally a service lift.
2. Remove the 6 bolts securing the endcap.
3. Remove endcap to expose spark arrestor screen.
4. Remove spark arrestor screen.
5. Vigorously brush spark arrestor screen with a wire brush
to remove accumulated residue.
6. After cleaning, replace screen and endcap. Securely
tighten the six endcap retaining bolts.
7.
Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot.
Maintenance Instructions
spark_arrestor_screen-005-105S
IMPORTANT - PLEASE READ CAREFULLY
!