Two Brothers Racing Yamaha R1 FE - Manual

IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a centerstand or ideally a service lift during installation. Be sure to save all stock
components for possible use later.
Installation Instructions
1. Remove passenger seat.
2. Locate fender wires and un-plug from main harness.
3. Remove the 3 bolts securing the OEM fender to
motorcycle.
4. Remove fender assembly.
5. Cut OEM wires on fender assembly back 6” (inches) from
plugs.
6. Attach gray plug to left side turn signal using the supplied
buttsplace connector.
7. Attach black plug to right side.
8. Attach the 2 bullet connectors to the plate light bolts.
Black goes to black.
Red goes to blue/red.
9. Attach turn signals and plate lights to TBR fender and
attach using the OEM bolts and supplied 6mm flange nuts
to motorcycle.
10. Route wires through center hole and plug into main
harness.
11. Use zip-tie tabs and zip-ties to keep wires away from
exhaust.
12. Double check all your work.
13. Re-install passenger seat.
14. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from inside
the pipe burning off. Check for gaps or leaks. If you find a
leak, a little high temperature silicon sealant should fix it.
After 50 to 100 miles, recheck all fasteners for tightness.
Qty. Description Part Number
1 Fender Bracket 005-23804B
2 Lighted License Plate Bolt 005-8504LTZ
1 Turn Signals (set of 2) 005-88T2
6 Butt Splice Connectors 005-BS1614
2 Zip Tie 005-ZT458B
2 Zip Tie Tab 005-ZTM4
3 6mm Flange Nut 005-FN6
1 TBR Sticker Kit 015-10212
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM 2009 Yamaha
R1
Fender Eliminator Kit
Part # 013-238
Parts List
WIRING DIAGRAM
Lef
t Tu
rn
Sig
nal
(Gr
ey
con
nec
tor
)
Blue/R
ed
Plate Lights
Righ
t Turn
Sign
al
(Blac
k con
necto
r)
Wiring Harness
Blac
k
Red
Blac
k
Blac
k
Red
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the
use of these products or parts.