Two Brothers Racing Harley Davidson Dyna User Manual
Dyna, Harley davidson

1.
Make sure the bike is completely cool before starting the installation
and secure on a service lift.
2.
Unplug O2 sensor connectors from wiring harness. Note: Pay attention
to wire routing for reinstallation.
3.
Loosen heat shield clamps on both the front and rear head pipes.
4.
Remove exhaust header nuts located at cylinder head. Keep these
for use with TBR Comp-S system.
5.
Remove front head pipe clamp bolt. Keep for installation with TBR
exhaust.
6.
Remove bolt that attaches muffler to mounting bracket.
7.
Remove OEM exhaust system.
IMPORTANT - PLEASE READ CAREFULLY
Two Brothers Racing products are intended for closed course competition
purposes only.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions
first before starting installation. Make sure the motorcycle and exhaust system
are completely cool before starting the installation. Also, make sure the bike
is secure on a center stand or ideally a service lift during installation. Be sure
to save all stock components for possible use later.
Note
Installation Instructions
Warranty Information
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are
sold “as is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability
or fitness for a particular purpose and disclaims all responsibility for consequential and incidental damages
or any other losses arising from the use of these products or parts. Not tested for use with OEM or aftermarket
accessories.
Harley Davidson
Dyna
Part # 005-3750199
1.
Use a zip-tie around header pipe to keep flanges from sliding down
the tubing. Be sure to remove zip-ties before starting bike.
2.
Spread hose clamps wide to clear header pipes. Close and fasten
once shields are in place.
8.
Remove OEM muffler bracket.
9.
Install TBR mounting bracket using provided 5/16”x 1 1/2” flange bolts.
10.
Install O2 bungs onto TBR headers. Use copper washers and anti-seize.
11.
Using snapring pliers, carefully remove the circlips and flanges from
the stock exhaust system. Install the stock flanges to the new TBR head
pipes. Check the condition of the circlips, we recommend replacing
them with new ones if they are bent or twisted.
**CAUTION** - Take care when installing black ceramic coated exhaust system. The coating can be scratched when installing heat shields and header flanges.