Two Brothers Racing Yamaha FZ8 - Manual

1. Make sure the bike is completely cool before
starting the installation. Make sure the bike is
secure on a centerstand or ideally a service lift.
2. Remove OEM muffler assembly.
3. Remove OEM muffler mount bracket.
4. Attach muffler to TBR slip system using the supplied
X-ring, 6x20mm socket head cap screws and lock
washers that are provided, leave loose for now.
5. Slide barrel clamp over slip-tube and install muffler
assembly to bike.
6. Slide rubber lined muffler clamp over muffler
assembly and loosely attach to rear lower
passenger foot mount using supplied 8x16mm bolt.
7. Check for clearance and alignment, then tighten all
the bolts in this order: X-ring bolts, muffler mount,
and finally barrel clamp.
8. Remove OEM heatshield and install on TBR system.
9. Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system
gets hot. Run the bike and enjoy. It is normal for
some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from
inside the pipe burning off. Check for gaps or leaks.
If you find a leak, a little high temperature silicon
sealant should fix it. After 50 to 100 miles, recheck
all fasteners for tightness.
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Parts List
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions first before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Also,
make sure the bike is secure on a centerstand or ideally a service lift during
installation. Be sure to save all stock components for possible use later.
Installation Instructions
Qty. Description Part Number
1 M-2 Muffler Canister Varies
1 Canister Clamp with Rubber Liner Varies
1 Header Kit 005-30504S
1 HARDWARE KIT 005-305-3
1 X-Ring Kit 005-7-2-3KIT
1 66mm Barrel Clamp 005-27-66MSH
1 8x16mm Flange Bolts 005-FB816
1 TBR Sticker Kit 015-10212
2011 Yamaha
FZ-8
V.A.L.E.™ Slip-on Exhaust System with M-2 Exhaust Canister
Part # 005-3050406V, 005-3050407V, 005-3050408V
Warranty Information
two brothers racing products are intended for closed course competition purposes only, and therefore are
sold “as is” without warranty. two brothers racing specifically disclaims any warranties of merchantability
or fitness for a particular purpose and disclaims all responsibility for consequential and incidental damages
or any other losses arising from the use of these products or parts. not tested for use with oeM or
aftermarket accessories.