Two Brothers Racing Triumph Daytona 955i CE - Manual

6. Use supplied springs to attach muffler to S-bend tube,
7. Slide muffler clamp over muffler and attach to muffler
mount using OEM hardware. Muffler clamp tabs
should be to the back of the mount.
8. Securely tighten all hardware.
9. Double check to make sure that all hardware is
tightened
10. Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system gets
hot. Run the bike and enjoy. It is normal for some
white smoke to appear the first time you start the
bike. This is packing/manufacturing oil from inside the
pipe burning off. Check for gaps or leaks. If you find
a leak, a little high temperature silicon sealant should
fix it. After 50 to 100 miles, recheck all fasteners for
tightness.
Parts List
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the motorcycle and exhaust system are completely cool
before starting the installation. Also, make sure the bike is secure on a center stand
or ideally a service lift during installation. Be sure to save all stock components for
possible use later.
Installation Instructions
1. Make sure the bike is completely cool before starting
the installation. Make sure the bike is secure on a
centerstand or ideally a service lift.
2. Remove stock T-bolt clamp clamp, muffler mount bolt
and muffler assembly.
3. Apply a thing bead of high-temp sealant around the
inside edge of the notched end of the S-bend tube. Place
the supplied T-bolt clamp on the notched end of the
s-bend tube and slip the assembly onto the OEM head
pipe.
4. Install VALE adapter kit using the supplied kit
instructions.
5. Apply a thin bead of sealant to inside of muffler collar
and slide muffler onto S-bend tube.
2002-06 Triumph
Daytona 955i
V.A.L.E.™ High Mount Slip-on Exhaust System with M-2 Canister
Part # 005-410406M, 005-410407M, 005-410408M, 005-410419M, 005-410420M
Qty. Description Part Number
1 Muffler Varies
1 Muffler Clamp Varies
1 S-Bend Tube 005-4104N
1 HARDWARE KIT 005-41-3
1 VALE Adapter Kit 005-2-1-V
2 80mm swivel hook spring 005-S80
1 66mm T-bolt Clamp 005-27-66MSH
1 Permatex Ultra Black Gasket Maker 031-P22072
1 T20 Torx Screw Wrench 005-9-15820
1 TBR Sticker Kit 015-10212
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.