Two Brothers Racing Suzuki B-King - Manual (Page 2)

2008 Suzuki
B-King
V.A.L.E.™ Slip-on Exhaust System with Dual M-2 Canisters
Part # 005-1950406DM / 005-1950407DM / 005-1950408DM
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Installation Instructions
Add parallel wire to both L & R turn signals and attach to
new turn signal brackets. A 10mm washer is provided to
use as a spacer for the turn signals in front of the OEM
nut. Zip tie wires away from exhaust tube.
Plug wires into main wire harness and attach to motorcycle.
Attach tail and plate light bolts as shown in Wiring Diagram.
You will need to cut the OEM plugs and attach with the
supplied connectors.
Check all lights to be sure they function correctly including
your brake lights.
Re-install the rear cowling and seat.
Double check all your work.
Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal for
some white smoke to appear the first time you start the
bike. This is packing/manufacturing oil from inside the
pipe burning off. Check for gaps or leaks. If you find a leak,
a little high temperature silicon sealant should fix it. After
50 to 100 miles, recheck all fasteners for tightness.
13.
14.
15.
16.
17.
18.
19.
Tighten the barrel clamp.
Attach tail led light and plate lite bolts to fender eliminator.
Remove wire harness and turn signals from OEM fender section.
Remove rubber grommets from frame and attach TBR
turn signal brackets using the OEM 8mm button head
S.H.C.S. and the 6x16mm flange bolt and nut provided.
9.
10.
11.
12.
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
LED Brake Light
Right Turn Signal Left Turn Signal
Light Bolts
Right Turn Signal
(Black/White & Black)
Left Turn Signal
(Lt. Blue & Black/White)
Brak
e Lights
Plate Light
Wiring Harness
Brown
Blac
k/White
White/Black
Red Green
WIRING DIAGRAM
Blac
k/White
Brown
R
ed
Blac
k
Black
* The splice connectors
can be heated to make
them waterproof. They will
shrink around the wires.