Two Brothers Racing Kawasaki ZX-6R - Manual (Page 2)

13. Tighten OEM joint clamp.
14. Install TBR fender eliminator kit using the original
bolts and supplied nuts, the nuts will be inside the
bike under seat.
15. Attach turn signals and plate light bolts using the wire
splice connectors supplied to the correct wires in the
harness as shown in the Wiring Diagram.
16. Re-install seats and covers.
17. Remove OEM sleeves from OEM mount and OEM
mid-pipe mount.
18. Double check all your work.
19. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you
start the bike. This is packing/manufacturing oil from
inside the pipe burning off. Check for gaps or leaks.
If you find a leak, a little high temperature silicon
sealant should fix it. After 50 to 100 miles, recheck all
fasteners for tightness.
Installation Instructions
Warranty
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
WIRING DIAGRAM
Parts List
Kawasaki
ZX-6R
Part# 005-3860405-S1
1 Muffler Canister 8” S1R
1 Muffler Clamp S1R Vertical
1 Slip-on Tube 005-24104S
1 Fender Bracket 005-19904B
2 Lighted License Plate Bolt 005-8504LTZ
1 Turn Signals (set of 2) 005-88T2
6 Butt Splice Connectors 005-BS1614
1 Zip Tie 005-ZT458B
1 Zip Tie Tab 005-ZTM4
1 Muffler Bracket 005-328-B
2 8x40mm Socket Head Cap Screw 005-SH840
4 6mm Flange Nut 005-FN6
1 8x25mm Flange Bolt 005-SH825
3 8mm Flange Nut 005-FN8
1 T20 Torx Screw Hex Key 005-9-15820
1 Permatex Anti-Seize 031-P09175
1 Spring Puller 005-SP
1 Spacer 005-S-8
2 Spring 45mm 005-S45
1 TBR Sticker Kit 015-10212