Two Brothers Racing BMW S1000RR - Manual (Page 3)

22. Install supplied TBR hex-head bolt.
23. Install supplied muffler mounting bracket to newly installed
bolt and secure in place with 8mm flange nut.
24. Attach TBR muffler to supplied slip-on tube using the
provided four 6x20mm socket head cap screws, washers
and thread-lock.
25. Install TBR muffler assembly to bike, use supplied barrel
clamp at joint and rubber lined muffler clamp
26. Loosely attach to bracket using the supplied bolt with decorated
washer and spacer using the supplied 8mm flange nut.
27. Align muffler and securely tighten the x-ring bolts in a cross
pattern.
28. Tighten the barrel clamp at mid-pipe joint, then muffler
clamp.
29. Re-install bodywork and check to be sure there is clearance
between exhaust tubing and all bodywork.
30. Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any protective plastic from the name badges
on the muffler canister(s) or the muffler clamp(s). Run
the bike and enjoy. It is normal for some white smoke to
appear the first time you start the bike. This is packing/
manufacturing oil from inside the pipe burning off. After
50 to 100 miles, recheck all fasteners for tightness.
Installation Instructions
2010 BMW
S1000RR
FullExhaust System
Part# 005-2810106V-B / 005-2810107V-B / 005-2810108V-B