Samson DOUBLE BRAID Class II Eye Splice Modified for TS-II Turbo User Manual
Page 2
PAGE 2 OF 8
SamsonRope.com
| Tel
+1.360.384.4669
Double Braid Class II Eye Splice Modified for TS-II Turbo
S A M S O N S P L I C I N G I N S T R U C T I O N S
u n b r a I D I n g C o V e r
3
step
p e r f o r M I n g e y e s p l I C e
4
step
Measure 1 fid length from Mark 4 towards Mark
3. Open up the strands of the core to expose the
Duravet reinforcing core. Cut the reinforcing core
at this point. Remove the Duravet core from this
point to the bitter end of the rope.
4
A
Tape the rope at Marks 2, 3 and 4. From Mark 3, measure 2 fid lengths towards Mark 4. Mark this point, then cut
the cover completely around the circumference of the rope. Be careful not to cut any of the core strands or yarns.
Unbraid the cover from the cut towards Mark 4, and from the cut towards Mark 3. The cover is left intact
around the eye, from Mark 2 to Mark 3. With the cover unbraided, transfer Mark 2 and 3 to the core.
Unbraid the cover from the bitter end to Mark 2.
After the cover has been unbraided, measure
1 fid length from the bitter end and make Mark 1.
Measure 1 fid
Mark 1
Keep cover on eye
Tape cover at
Marks 2, 3 and 4
reMoVe reInforCIng Core
Pull Duravet core
out of eye section
of rope and discard.
Measure 1 fid
Cut Duravett core