Samson DOUBLE BRAID Class II End-for-End Splice Modified for Turbo-37 User Manual

Samson Tools

PAGE 1 OF 4

SamsonRope.com

| Email

[email protected]

| Tel

+1.360.384.4669

Double Braid Class II End-for-End Splice Modified for Turbo-37

S A M S O N S P L I C I N G I N S T R U C T I O N S

Tape the end of each sub-rope. This should be done

immediately after removing the cover to prevent unlaying.

m e a s u r i n g a n d m a r k i n g

step

installing splice cover material

Using an appropriate size and approx 1.7 times splice length of cover material (splice length approx. 60 times rope diameter), slide the

cover onto either end of the rope, and slide past Mark 3. This will be used later to cover the exposed sub-ropes in the splice area.

On each of the 2 ends to be spliced together measure 33 times rope diameter. This is Mark 1. From Mark 1, measure an addi-

tional 20 times the diameter, this is Mark 2. Now make Mark 3, 10 times the diameter beyond Mark 2. Tape securely at Marks 3.
Note: Mark 1 on the cover is for reference only; however, each sub-rope will be marked at this location after cover removal.

step

r e m o v i n g c o v e r

Carefully cut the cover of the rope at Marks 2, and remove from rope. Unbraid the cover from

Marks 2 back to Marks 3. This material will be used later to incorporate the cover into the splice.

step

ta p i n g s u B - r o p e s

10 ×diameter

20×diameter

33×diameter

mark 3

mark 2

mark 1

mark 2

tail

Unbraided

cover

Unbraided

cover

33 × diameter

mark 1

Unbraided

cover

Unbraided
cover

33 × diameter

m a r k i n g s u B - r o p e s

step

Arrange sub-ropes as shown, taking care that all are laid straight.
From the bitter ends of the sub-ropes, measure 33 times the rope diam-

eter and mark each one at exactly the same point.