Connect power cord and turn on the machine – Canon MF4370DN User Manual
Page 14
12
2 Set Up the Machine
1
Connect the power cord into the rear socket on
the back side of the machine and the wall
outlet, and press the [I] side of the main power
switch (A) to turn ON.
Do not connect the machine and the computer with a USB
cable at this time. Connect the machine and the computer
with a USB cable only during the software installation
procedure. (A USB cable is not used when the machine is
used via a network connection.)
2
The machine enters the standby mode.
T E X T / P H O T O 1
1 0 0 % L T R
The LCD display turned OFF:
The machine may enter the Sleep mode while you are performing setup. Press
[Energy Saver] to turn the display back ON and continue the setup.
Make sure that the toner cover and scanning platform are closed properly. (See
“Install Toner Cartridge,” on p. 5.)
Check the installation of the toner cartridge and the placement of the paper.
(See “Install Toner Cartridge,” on p. 5 and “Set Up Paper Cassette and Load
Paper,” on p. 8.)
●
●
●
Connect Power Cord and Turn On the Machine