Dell OptiPlex NX1 - Manual (Page 56)

2-4 Dell OptiPlex GX1/GX1p Managed PC and OptiPlex NX1 Net PC Systems Service Manual
‡
System error messages: These messages can indicate problems or
provide status information. If a system error message is displayed, see
Table 3-2.
‡
Beep codes: A beep code is a series of beeps that indicates an error
condition. If the system emits a beep code, see Table 3-1.
5. Observe the monitor screen for the Diagnostics Menu.
Does the Diagnostics Menu appear?
Yes. See “Running the System Diagnostics” found later in this chapter.
No. Proceed to step 6.
6. Insert another copy of the Dell Diagnostics Diskette into the diskette drive,
and reboot the system.
Does the Diagnostics Menu appear?
Yes. See “Running the System Diagnostics” found later in this chapter.
No. Proceed to the next section, “Internal Visual Inspection.”
,QWHUQDO9LVXDO,QVSHFWLRQ
&$87,21 %HIRUH \RX SURFHHG ZLWK WKH LQWHUQDO YLVXDO LQVSHFWLRQ
GHVFULEHG LQ WKLV VHFWLRQ HQVXUH WKDW WKH XVHU KDV VDYHG DOO RSHQ
ILOHV DQG H[LWHG DOO RSHQ DSSOLFDWLRQV LI SRVVLEOH
A simple visual inspection of a computer’s interior hardware can often lead to
the source of a problem, such as a loose expansion card, cable connector, or
mounting screw. When you perform the visual inspection, refer to Figures 1-3
through 1-6 as appropriate for your system for component location information.
To perform the internal visual inspection, follow these steps:
1. Turn off the system, including any attached peripherals, and disconnect all
the AC power cables from their power sources.
2. Remove the computer cover.
3. Verify that all chips, DIMMs, and expansion cards are fully seated in their
sockets or connectors.
:$51,1* 7KH VLQJOHHGJH FRQWDFW 6(& FDUWULGJHKHDW VLQN
DVVHPEO\ FDQ JHW H[WUHPHO\ KRW %H VXUH WKDW WKH DVVHPEO\ KDV
KDG VXIILFLHQW WLPH WR FRRO EHIRUH \RX WRXFK LW
&$87,21 :KLOH UHVHDWLQJ WKH 6(& FDUWULGJHKHDW VLQN DVVHPEO\
XVH D ZULVW JURXQGLQJ VWUDS RU PDLQWDLQ FRQWDFW ZLWK D PHWDO VXU
IDFH RQ WKH FKDVVLV
The microprocessor is physically located in a SEC cartridge/heat sink
assembly on the system board. To reseat the microprocessor, remove the