Dell Vostro 200 (Mid 2007) - Manual (Page 134)

134
Removing and Installing Parts
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
11 Connect your computer and devices to electrical outlets, and then turn
them on.
12 See the documentation that came with the drive for instructions on
installing any software required for drive operation.
13 Check the system setup for drive configuration changes (see "Entering
System Setup" on page 174).
Floppy Drive
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
NOTE:
If you are adding a floppy drive, see "Installing a Floppy Drive" on page 136.
Removing a Floppy Drive
1 Follow the procedures in "Before You Begin" on page 101.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 103).
3 Remove the bezel (see "Removing the Bezel" on page 123).
book.book Page 134 Thursday, June 14, 2007 6:23 PM