Dell Dimension 2300 - Manual (Page 41)

IDE Primary Master Submenu
Diskette Configuration Submenu
Event Log Configuration Submenu
Option Function
IDE HDD Auto-Detection Press to start auto-detection for the primary IDE hard drive.
IDE Primary Master Specifies the type of hard drive. Settings for this option are Auto (default), None, and Manual.
Capacity Displays the maximum capacity of the primary IDE device.
Cylinder, Head, Precoup, Landing Zone,
Sector Displays each setting of the primary IDE device.
Access Mode Sets the access mode of the primary IDE device. The options are Auto (default), CHS, LBA, and Large.
PIO Mode Sets the PIO mode of the primary IDE device. The options are Auto (default), Mode 0, Mode 1, Mode 2, Mode 3,
and Mode 4.
UDMA Mode Sets the ultra DMA setting of the primary IDE device as either Auto (default) or Disabled.
Option Function
Diskette Controller Configures the floppy drive interface. Options are Enabled (default) and Disabled.
Drive A: Selects the floppy drive type as 1.44M, 3.5 in (default); None; 360K, 5.25 in; 1.2M, 5.25 in; 720K, 3.5 in; or 2.88M, 3.5 in.
Floppy 3 Mode
Support Selects Floppy 3 mode support for the floppy drive. Options are Disabled (default) and Drive A.
Diskette Write
Protect Protects a floppy disk from being written to when set to Enabled. When this option is set to Disabled (default), the floppy disk is not
protected unless the write-protect tab is in place.