Dell PowerVault 745N - Manual (Page 2)

Dell PV745N Release Notes
file:///T|/htdocs/stor-sys/spv745N/en/RN/RelNotes.htm[12/5/2012 10:17:35 AM]
---------------------------------------------------------------------------------------------------
12/6/2004 | Resource CD | 3.4.9.1 | Documentation changes:
* New OpenManage version 4.1
* ArrayManager version 3.6
USB Key Prep Utility to accommodate
new USB keys
---------------------------------------------------------------------------------------------------
3/28/2005 | Reinstallation CDs | 3.4.9.1 | Update OpenManage 3.71 --> OpenManage 4.1
OpenManage 4.1 software components:
* Server Administrator 1.9
* ArrayManager 3.6
* Server Assistant 5.2
* Online Diagnostics (OL-D) 3.1
* Local Update Service 1.9.1
* Remote Access Controller (RAC) 3.3
---------------------------------------------------------------------------------------------------
10/10/2005 | Reinstallation CDs | 3.4.9.2 | Update to Windows Server 2003 Service Pack 1
Update OpenManage 4.1 --> OpenManage 4.4
OpenManage 4.4 software components:
| Resource CDs | 3.4.9.2 | Documentation changes:
OpenManager version 4.4
Array Manager 3.7
PV745N Information Update Tech Sheet
---------------------------------------------------------------------------------------------------
===============================================================
Managing UPS Services Through the NAS Manager
===============================================================
Problem:
When starting/stopping the UPS management service, the system generates a 413E010D
UPS CONFIGURATION error message on the NAS Manager Status page and required the
system to be rebooted to clear.
Solution:
When managing a UPS attached to the NAS system through the NAS Manager, always use the
Maintenance--> UPS link to configure and start the UPS management service. Using any other
link to start/stop the UPS services may generate an error.
===============================================================
1 TB Limit When Upgrading to Dynamic Disk
===============================================================
Problem:
When trying to convert any disk over 1 TB to dynamic using Disk Management (LDM), an error
message states that the operation did not complete and to check the system event log for more
information. However, no error appears in the event log
Cause: