Dell XPS 710 - Manual (Page 75)

System Setup: Dell XPS 700 Service Manual
syssetup.htm[4/11/2014 11:32:17 AM]
Off — All floppy drives are
disabled.
USB — USB floppy drives are
enabled
Internal — The integrated floppy
drive is enabled.
Read Only — The integrated floppy
drive is enabled with read-only
access.
NOTE: Operating systems with USB
support will recognize USB floppy drives
regardless of this setting.
SATA Drives 0 through 5
(On default)
Enables or disables drives attached to the
SATA connectors on the system board.
Off — A device attached to the
interface is not usable.
On — A device attached to the
interface is usable.
RAID On - A device attached to
the interface is configured for RAID
(see "About Your RAID
Configuration" in your Owner's
Manual).
PATA Drives 0 through 1
(On default)
Enables or disables drives attached to the
ATA connectors on the system board, and
lists the controller details.
Off — A device attached to the
interface is not usable.
On — A device attached to the
interface is usable.
SMART Reporting
(Off default)
Determines whether hard-drive errors for
internal drives are reported during
system startup.
Off — Errors are not reported.
On — Errors are reported.
Onboard Devices
Integrated NIC
(On default)
Enables or disables the integrated network
interface controller (NIC).
Off — The integrated NIC is
disabled.
On — The integrated NIC is
enabled.
On w/PXE — The integrated NIC is
on (with PXE enabled).
NOTE: PXE is required only if you are
booting to an operating system located
on another computer. If a boot routine is
not available from the remote system,
the computer attempts to boot from the
next device listed in the boot sequence.
Integrated Audio
(On default)
Enables or disables the onboard audio
controller.
Off — Integrated audio is disabled.