Dell Inspiron Desktop (3847, Early 2013) - Manual (Page 37)

Removing the Power-Button Module | 37
Removing the Power-Button Module
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 9. For more safety best practices,
see the Regulatory Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the computer cover. See "Removing the Computer Cover" on page 12.
2 Remove the front bezel. See "Removing the Front Bezel" on page 19.
Procedure
NOTE: Note the routing of the cable as you remove it so that you can re-route it
correctly after you replace the power-button module.
1 Disconnect the power-button module cable from the system-board connector
(LEDH1). See "System-Board Components" on page 11.
book.book Page 37 Tuesday, November 12, 2013 1:54 PM