Dell Inspiron Mini 10v (1018, Mid 2010) - Manual (Page 35)

9. Using your fingertips, gently ease the palm rest assembly from the computer base.
10. Lift the palm rest assembly off the computer base.
Replacing the Palm Rest Assembly
1. Follow the instructions in Before You Begin .
2. Align the palm rest assembly on the computer base and gently snap the palm rest assembly into place.
3. Slide the touch pad cable into the connector on the system board and press down on the connector latch to secure the touch pad cable.
4. Connect the power button cable to the connector on the system board.
5. Replace the three screws that secure the palm rest assembly to the computer base.
1 power button board cable connector 2 touch pad cable
CAUTION: Carefully separate the palm rest assembly from the computer base to avoid damage to the palm rest assembly.
1 screws (3)