Dell POWEREDGE M905 - Manual (Page 139)

Installing Blade Components
139
Figure 3-22. Installing and Removing an HT Bridge Card (PowerEdge M805 Only)
Installing an HT Bridge Card
1 Perform the following steps to prepare the two sockets on the new system
board:
a Remove the processor filler blank
b Lift the plastic processor socket cover from the socket.
c Unlatch and rotate the socket-release lever 90 degrees upward.
d Lift the processor shield.
e Repeat steps a through d to prepare the second processor socket.
1 HT bridge card 2 socket-release lever
3 processor shield 4 notch in card
3
1
2
4