Camera module, Removing the camera module, Replacing the camera module – Dell Studio 1458 (Early 2010) User Manual
Page 11
Back to Contents Page
Camera Module
Removing the Camera Module
1.
Follow the instructions in
Before You Begin
.
2.
Remove the system board (see
Removing the System Board
).
3.
Remove the WWAN module (see
Removing the WWAN Module
).
4.
Remove the display assembly (see
Removing the Display Assembly
).
5.
Remove the display bezel (see
Removing the Display Bezel
).
6.
Remove the display panel (see
Removing the Display Panel
).
7.
Disconnect the camera module cable from the camera module cable connector.
8.
Remove the two screws securing the camera module to the display cover.
9.
Lift the camera module off the display cover.
Replacing the Camera Module
1.
Follow the instructions in
Before You Begin
.
2.
Align the camera module over the screw holes on the display cover.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
1
screws (2)
2
camera module
3
camera module cable connector